throttle cable sleeve

on the throttle cable sleeve there is 2 slits 1 that goes all the the way through and 1 only that goes quarter the way up,do i line the 1 that goes quarter the way up with the idle screw????well the screw thing i think its the idle screw??? thanks fellas

i got the sucker back in!!went for a quick fang and was working all good but when i came back i lifted the back wheel to see if all was good ,gave it a bit of exelleration and it seems to get caught on while of the ground,but when i put wheel back down it stops(automatic clutch).is it better to have the idle screw right down or right up for peformance??

thnx fellas for all your help

so your try to say that the back wheel keeps spinning when off the ground but when you put it back on the ground it stops?

Take off your clutch housing (the thing your front sprocket is on) there is 4 allen key bolts, undo them then see if the clutch springs are ok....

if one is broken you need to buy a new one and that was the cause of your back wheel spinning...

also dude, try and keep your question to 1 topic.. its a lot easier man and he doesnt clog up the forum.. GL with the bike.

__________________

TEAM GMR - When Appearence Matters
★ 140cc Mini Motard - Billetware frame, Billetware swingarm QLD #3
★ 40cc SQ watercooled - Stock yet faster and more reliable than yours.

TyD is probably right. You may have a dud spring in your clutch. PBP has replacement springs, as well as other parts <as mentioned previously>.


Don't worry about keeping it to one question, i'm sure not everyone minds, i certainly dont

Like me mum used to say, "if you don't ask, you'll never find out." Except when she was saying "You little bastard!!"

Oh, if your idle screw goes in to far it'll just rev it's tits off and make trying to stop awful good fun.


Regards,


Claw

__________________
Remember, TheClaw loves you all..Accept no substitute!