Making a Cag HP Pipe

[The Almost :]]

ok so, my friend and I are trying to make a custom HP cag pipe....

^^Demo Photo^^


I was wondering how should we make it

big or thin?

and would we have it go over the spark plug (like a fat boy?)

or around the cyclender(like a jet pro)


I dont know if this is possible, but worth the try .



open to suggestions...


btw

we are trying to put it on a Half Fairing cag

[Glen]

id take the stock pipe and cut the center section out and make it much fatter. that will be alot easier for you.

and what welder is that done with? looks like a mig. you have to turn down the wire feed and go much slower! and weld in a weaving action. it looks like itll leak heaps

[mac90]

id try using the cones from the stock pipe also, & just put a fatter extended ring between them & remake a larger header ,
then just use the old header pipe for the stinger

then again thats a bit of effort id go the lazy way & just buy a jetpro rep lol

[The Almost :]]

yea that sounds dope....


Ill try the stock pipe mod then...


^^But, im still thinking of doing something like this^^


that looks sick!!!

[Glen]

thats an aftermarket pipe of some kind, looks nice though. have to lower that front fairing though haha!

[mac90]

that could be a old pbu bazooka in that pic i think ?
with interchangable stingers one of the few pbu cag parts worth the $$$ you pay with their products

[akim21]

haha thats my bike!!! woot lol