banshee over flowing

[barnsey]

hey guys i seem to have a bit of an issue with my banshee...
well i had a bent needle (carbie needle) and the bike was allways over flowing out the over flow(durr) i was rididng it the other day it was running good untill after about 2 mins and it took ages to pick up revs.. than when i snaped on the throttle to take-off it bog down than pick up revs again ..so i changed the needle and now it dosnt leak as much when its turned off but as soon as i start-it it over flows.... when i turn it off it still leaks
cheers beau

[beans]

the float level sound like its to high.do a little bending to lower it

[barnsey]

buy how much should i lower it

[mac90]

the prongs & or float should be level (horizontal) with the carby base at minimum when full
its usually easyer to take the carb off & set it up while upside down

dazza posted a how to link for setting 19mm blata carbs im sure if you can find it it would be the best way to go, or will give you the idea how to set them up