head kit "flat side"

[razor-]

Hey.
I got this head kit of ozminimoto and i installed it with the "flatside" of the head to the exhuast post i figured that this must be for clearance but just then i went to install the coil and it hits the top of the head..
The only way i could prevent this is if i put the flat side of the head facing the flywheel but would that still give an exhuast clearance??


Also with the new headkit it looks crappy with the coil so would it matter if i cut off the loose bit of rubber from the sparkplug end of the coil?

http://www.ozminimoto.com.au/cartima...0end%20kit.JPG

[barnsey]

thats how i put one on with the flat side against the coil..and yess it would it wouldent be able to hold the plug and connect it up

[razor-]

what i mean is this.. If i cut where the red line is
http://images-041.cdn.piczo.com/i2/v...6499_64566.jpg

http://images-041.cdn.piczo.com/i2/v...6500_69459.jpg

[hudson44]

Originally Posted by razor-

what i mean is this.. If i cut where the red line is
http://images-041.cdn.piczo.com/i2/v...6499_64566.jpg

http://images-041.cdn.piczo.com/i2/v...6500_69459.jpg

Yeah that will be fine. Mine's cut off

[razor-]

kk thanks....