Trouble Shooting Guide - Cags - Add yours

[Madracer]

Kepped Fouling up Plugs, after 4 plug changes.
Bike wont Rev.Lots ands Lots of smoke
Jet had fallen off end of pick up.
2 Secs to put it back on

[gromet]

Problem: the bike wouldnt rev oouuuuuutttt.........
cuase: i made a new exhust gasket and made it 1mm to smell on one side.
resolution: cut it the right size !!!!

[lefty]

Problem: Bike turning off
Symptoms: Bike running then stalling
Cause: Plastic fuel switch rubber broke into bits, made its way through carb, all blocked up, fuel not getting to piston.
Resolution: Pull the switch apart & carb, remove all the little plastic bits.
Cost: $0 to clean, get a new platic switch from lawn mower place or cut the inside rubber of the switch so that its always on, and buy an in-line fuel tap.

[mini_moto]

Probem: Bike not starting
Symptoms: bike not starting, not turning over
Causes: stuck floats, jamed needle
resolution: took bowl off and pulled needle out and blew it with wd-40

[Bandy]

New cags with chromed plastic fuel caps.
The chrome is over the vent hole and bike runs out of fuel.(can't breath)
Drill it out or dig it out with an NT cutter like we did.
Instant Fix.