pmt v pump

[barnsey]

hey guys ive just got pmts on my bike and well yesterday they looked a bit flat so i pumped them up with my brand spaking new pump(a christmas presant from mum which i payed for!) the tires seem to pump up good but to day they are flat so i was trying to pump up the rear and every time i pused the pump down i culd here air gushing out i dont no where from but i think its the valve how do i fix or tighten that also my pump fell a part the peice of s#%t .... also im runing mower fuel with a rich mix will that dramitclay reduecs it preformance? i only through a bit in because mum mixd up my tin for the bike with the mower oil and ratiio

[SAMMY]

wen u put the tires on u have 2 pump tghem up 2 like 60 psi first then let them totslly down then pump it up to the desired psi u do it so the edge of the tie seals 2 the rims

[Squeeby]

Tubeless tyres need a big rush of air to push the bead on to the rim. You won't get that without an air compressor.

[mac90]

if they are tubless tyres u need to seal the bead (around the edge) of the tyre to the rim

a compressor should do it no probs if not you can punch the top of the tyre a few times it may help them seal, a little soap & water around the inner edge might help it seal & slip on better

if its a tubless valve it may be leaking u will need to replace it
or the bead of the tyre may be damaged this will cause a leak.

another thing tubless tyres dont alwayse work on chinese rims, the casting may be pourous or just rough as guts & will leak,
.. a easy fix is to paint the inside of the rim with rubber or a latex sealant , or a few coats of paint

if they have tubes the valve may have moved if you rode the bike when it was almost flat & tore the valve from the tube

[barnsey]

ok i will do it a dads on the week end so around 60 psi? so fiil it to 60 psi than leave it or deflate it straight away than do it again?