parts sale v2.

Glen · #1 (**permalink**) 22-07-2008, 04:53 PM

A few new items and some old.

Blata radiator. mounted on my gp3 and used once at the track. all the cores are pristine. comes with top mounts and pipes (some are shortened) + clamps. $120

Blata sprockets - 66 and 68 tooth. they came with my banshee i cant use them as all my bikes run water pump rear sprockets. also a 70 tooth stock sprocket off the dreambike. $30 for all of them or $15 each.

Glen · #2 (**permalink**) 22-07-2008, 04:54 PM

Random brand water pump pulley - came with the dreambike. i bored the inside out and drilled 2x holes in it to mount it up to a bzm sprocket. i had to drill the sprocket to fit it iirc. but you could tap a grub screw in their sideways to hold it to the hub ideally. $5

Gp3 replica ignition boxes x 2 stock as a rock and both working $10 each

Dreambike replica coil. should fit the banshee also. stock as a rock again and working just fine. $15

Glen · #3 (**permalink**) 22-07-2008, 04:55 PM

Gp3 replica radiator. i recieved it from WBR a few months ago with a reverse motor. i dont need it. cores still in good condition but the top has been mashed in a bit in shipping or from them who knows. still flows just fine. $20

Two GP3 rep pipes. one has no header. one ive drilled out the internals silencer to try quieten it down a little which didnt really worl haha! but i run a zocchi pipe in my rep now so no need for these. $20

Replica brake pads. should fit the samurai cags and 90% of replica watercooleds. came off both the GP3, dreambike and banshee. i run expensive GRC pads now. but these work just fine. i believe there is 7 pairs of them all have plenty of meat still left. $20 for all of them.

thanks.

Glen · #4 (**permalink**) 22-07-2008, 04:57 PM

stock dreambike crank, should fit in the banshee as well. has a straight cut crank so you can put all the good clutches on never used. $20

Unifilter. used on the gp3. no rips or tears or leaks. its the straight type. it hink youd only fit it on a blata rep. $10

Remote choke setup. i ripped it off the banshee because i thought it was leaking but this was not the case. the stock choke works just fine on the chee. fits PHGB genuine and rep. theres a few cracks in the lever housing but still works alright. $5

BZM 620 cases. totally untouched and as new with alloy plug and case springs. i bought these to make a motor but i realised i have to get the BZM head which just isnt economical right now. so ive got a better solution that lets me run my polini based stuff. $270 on that with the plug and springs.

still have a stock polini dreambike rep barrell + head and 2x coolant bottles here as well make me an offer on them.

cheers