my beast, 46cc blata

[minimotorider]

Here is my new bike, its a blata rep.

Here is a few pics.





I started with the rebuild by taking off the fairings

the next part was to remove the fuel tank


I drew up a piece of paper with double sided tape to match up the screws

[minimotorider]

Here is my selection of screws that i used for the main chassis,

these are the bolts that were used for the rear trailing arms.


These are the bolts installed on the bike.

I changed these too.




Next was the motor,
I wanted to install my headkit (46cc)

[minimotorider]

Here is the crank


I hate that gasket goo stuff, so hard to get off
I noticed with the bike though that part of the motor had been machined,
this matched perfectly with the small piece missing off the actual cylinder guides on the cylinder