| unfortunately I i dont have a dome. I have a polini rep head that im going to put on and the standard cylinder thats too long to be able to make serious adjustments. Ive been told that the polini rep head is good tho and will lower the squish enought to get some room for port raising. If I was to machine the cylinder down from the top then we would be talking. what sort of dome head would fit a banshee? Also do you know anyone I could take my cylinder too to cut it down in melbourne? Also im not sure what a BDC is. Is that the bottom of the stroke? do you want the crown of the piston exactly in line with the bottom of the exaust port at its lowest point? Massive thread jack here sorry..
__________________
The Bitch
49cc Aircooled Cag
JetPro Pipe - Fiberglass Reeds - Race Clutch Springs - Race fuel filter and lines - 14/14 Genuine Dellorto SHA - RD 3D Boost ported head kit
Half Fairing Banshee
BZM Clutch springs - BZM clutch Bell and Pinion - 19mm PHBG Dell Rep - GRC Kill switch - BZM orange coil - Polini Gaskets and Polini Rep head - BZM carbon reeds - port n polished - PMT T43
Last edited by Benny88 : 23-08-2008 at 04:37 AM.
| 
