Give both surfaces a thorough clean with 'metho' or 'wax and grease remover'..
Give both surfaces a good brushing with a wire brush to ensure all built up junk is removed..
Again give both surfaces a good wipe down with metho or grease remover..

Apply gasket sealer to pipe and assemble..

Have a good think about where to apply it, so as when you push the two together it is no going to ooze to the inside of the pipe.. Any excess on the outside I don't wipe away, instead I leave it there and wipe it all around the whole joint and onto both side's of the join, but no overkill is required on the outside..

If you try to apply the sealer to a dirty, oily pipe.. It will blow out in no time at all..

__________________
SMALL WHEEL SUNDAYest 2008


@ LAKESIDE PARK

SWS forum here >>>> http://swslakeside.46.forumer.com/ <<<<